GarrettCom DynaStar DS2000-TS User Manual

A
PPENDIX
C -
System Functions
SNMP
DS2000-TS Administrator’s Guide
C - 9
C.8 SNMP
The path to SNMP is Main menu, <3> System, <7> SNMP. The SNMP sub-menu allows you to setup the
various SNMP parameters associated with this DS2000-TS. This setup will be necessary in order to use
SNMP to configure the unit remotely or use the SNMP trap generator to report port Link Status changes to a
remote network management server. The DS2000-TS can send TRAPS (Port status changes) to as many as
four remote systems. Enter the IP address of the remote servers and enable the “Enable Trap” field. The
Traps generated will include a status of up/down/time and Port Number.
Figure C-9. SNMP Parameters Menu
NOTE: In order to use SNMP, the “Local/ROM Address” must have an assigned IP address as described in
“Assign IP Addresses And Protocols” on page B-5.
The definitions, defaults, and permitted values of the SNMP Parameters screen are provided in the following
table.
Table C-1. SNMP Parameter Definitions
Parameter Description Default Range
System
Description
A textual description of the system used to set the MIB-II
sysDescr variable.
DynaStar
2000
48 characters
System
Contact
The name of a contact person for the
DS2000-TS
, together
with information on how to contact this person. It is used by
the Supervisor to set the MIB-II sysContact variable.
null 48 characters
System Name
The identifier for the
DS2000-TS
that the Supervisor has
used to set the MIB-II sysName variable.
null 48 characters
System
Location
The physical location of the
DS2000-TS
(e.g., “telephone
closet, 3rd floor”). It is used by the Supervisor to set the MIB-
II sysLocation variable.
null 48 characters
*** SNMP Parameters ***
Last changed: 7-14-04 12:33:29
________________________ Enter a maximum of 48 characters ---------------------
System description: DynaStar 1500
System contact:
System name:
System location:
Read-only Community name:
Read-write Community name:
Private Community name:
--------------- Enter 4 integers, 0-255, separated by a period ---------------
Trap IP address: 0.0.0.0 Trap IP address: 0.0.0.0
Trap IP address: 0.0.0.0 Trap IP address: 0.0.0.0
________________________ Use RET to toggle value ------------------------------
Enable authentication: N
Enable traps: N
__________[DynaStar_24]___________ Process selections (Y/N): Y
To change or add entry, enter new value Use <CTRL-D> to delete entry
Use TAB & CURSOR keys to move among fields Press ESC to abort command & exit

GarrettCom DynaStar DS2000-TS Specifications

General

Brand	GarrettCom
Model	DynaStar DS2000-TS
Category	Server
Language	English