C
HAPTER
3 -
Configuration Basics
Terminal Server Configuration Example
DS2000-TS Administrator’s Guide
3 - 2
Figure 3-1. Terminal Server Configuration Example
3.1.1
Assigning an IP Address to the System for TerminalServer
Functionality
In this section the user will configure the IP port information for the Router and the serial port. This section
configures IP information for the local DS2000-TS.
1. From the Main menu select <2> Network, <1> Router. The Router Setup and Status menu
appears, as shown in Figure 3-2.
Figure 3-2. Router Setup And Status Menu
Port E1
192.168.1.1
255.255.255.0
Serial
Socket 10201 (S1)
192.168.1.2
255.255.255.0
DynaStar 2000-TS
Ethernet
192.168.10.1
255.255.255.0
192.168.10.2
255.255.255.0
Management
Device
Serial
Socket 10201
DynaStar
Socket 10202 (S2)
B
A
Ethernet LAN
*** Router Setup and Status ***
1 - IP Port Configuration Configure port IP addresses
2 - IP Routes Display Display IP routing table contents
3 - IP Static Routes Configure static IP routes
4 - IP Filters Configure IP address filters
5 - TCP/IP Status Display TCP connection status
6 - OSPF Configuration Configure OSPF
7 - DHCP Configure and display DHCP
8 - VPN Configure and display VPNs
9 - VRRP Configure and display VRRP groups
10 - TCP Multicast Configure and display TCP Multicast groups
Enter command number:
_________[DynaStar_6b2c]__________
Terminate input with <RET> Press ESC to return to previous menu
To Next Page
Loading...