A
PPENDIX
B -
Network Commands
Router (IP)
DS2000-TS Administrator’s Guide
B - 5
Figure B-3. Router Setup And Status Menu
B.2.1 Assign IP Addresses And Protocols
To assign IP addresses to DS2000-TS ports that have been enabled for IP support, select option <1> IP Port
Configuration from the Router Setup and Status menu.
Figure B-4. IP Port Information
*** Router Setup and Status ***
1 - IP Port Configuration Configure port IP addresses
2 - IP Routes Display Display IP routing table contents
3 - IP Static Routes Configure static IP routes
4 - IP Filters Configure IP address filters
5 - TCP/IP Status Display TCP connection status
6 - OSPF Configuration Configure OSPF
7 - DHCP Configure and display DHCP
8 - VPN Configure and display VPNs
9 - VRRP Configure and display VRRP groups
10 - TCP Multicast Configure and display TCP Multicast groups
Enter command number:
_________[DynaStar_6b2c]__________
Terminate input with <RET> Press ESC to return to previous menu
*** IP Port Information ***
Last changed: 12-11-05 6:10:53
Port(s) Interface IP Address IP Mask |-Use RET to toggle|
x.x.x.x x.x.x.x Protocol Encaps
E0 Ethernet 192.168.1.1 255.255.255.0 RIP II Enet II
_________[DynaStar_6b2c]__________ Process IP Addresses (Y/N): Y
Lines with port ranges are multiport interfaces. Configure these ports together
on one line. Or with cursor on line, press <CTRL-O> to configure separately.
*Fields are blank on this screen if ports are configured separately.
To Next Page
Loading...
Need help?
General
