GarrettCom DynaStar DS2000-TS - Page 121

A
PPENDIX
D -
Security Commands
Security Options
DS2000-TS Administrator’s Guide
D - 9
Table D-2. Console Monitor Logging Parameters
Parameter Description Default
Log Logons When enabled, each logon generates
a log entry.
Y
Log Logouts When enabled, each logout
generates a log entry.
N
Log Failed Password When enabled, an invalid password
entry generates a log entry.
Y
Log Max Failed Password When enabled, generates a log entry
if the maximum permissible
(successive) number of password
failures occurs. The maximum is fixed
at 3.
Y
Log Failed UserID When enabled, generates a log entry
when an invalid UserID is used.
Y
Log Max Failed UserID When enabled, generates a log entry
if the maximum permissible
(successive) number of UserID
failures occurs. The maximum is fixed
at 3.
Y
Alarm Logons When enabled, each logon generates
an SNMP trap.
N
Alarm Logouts When enabled, each logout
generates an SNMP trap.
N
Alarm Failed Password When enabled, an invalid password
entry generates an SNMP trap.
N
Alarm Max Failed Password When enabled, sends an SNMP trap
if the maximum permissible
(successive) number of password
failures occurs. The maximum is fixed
at 3.
Y
Alarm Failed UserID When enabled, sends an SNMP trap
when an invalid UserID is used.
N
Alarm Max Failed UserID When enabled, sends an SNMP trap
if the maximum permissible
(successive) number of UserID
failures occurs. The maximum is fixed
at 3.
Y