Gasboy Islander PLUS - 4-7.2. Parameters for Printing; 4-7.3. Cutter; 4-7.4. Printing the Status Report; Figure 4-7. Printer Module- Jumpers Configuration Examples

Figure 4-7. Printer Module– Jumpers Configuration Examples
4-7.2. Parameters for Printing
The Printer features two printing modes, as determined by the controller in the Head Office:
• Print only when the door is lifted – Paper save mode
• Print always
4-7.3. Cutter
The paper cutter may be set to one of three modes, as determined by the controller in the Head
Office:
• No Cut
• Full Cut
• Partial Cut
4-7.4. Printing the Status Report
The G2 Printer enables producing a printer status report. Proceed as follows:
1. Turn off the printer
2. Open the printer’s service door
3. Turn on power to the printer
4. The G2 Printer prints a status report.
Islander PLUS Manual
87