NOTE
Do not attempt to release the paper using sharp
objects such as a knife or a screwdriver. Doing so
will damage the printer paper cutter and void your
warranty.
Do not attempt to pull the paper from the printer.
Doing so will damage the printer.
Perform the following procedures to release the paper when a paper jam occurs.
1. Open the printer front panel with its key.
2. Pull up the printer cover and release the green locking handle.
3. Pull out any crumpled paper
4. Clean the printer area from any paper remnants
5. Push the green paper-lock lever to its original state.
6. Slide the new paper roll into the Pivot Handle. Make sure the paper roll you
insert is not crumpled.
7. Insert the paper into the printer either automatically or manually.
4-11. THERMAL PAPER STORAGE
The thermal paper is sensitive to the environmental conditions where it is stored.Just as well, the
Printer Module operation is sensitive to the type of paper inserted. Proceed as follows:
• Use the right paper as specified.
• Insert the paper edge to the printer.
• Insert the paper in the correct side.
• Store the paper in a dry, shaded area, at 64 to 68 ºF (18 to 20 ºC).
• During paper replacement, avoid dust, moisture and rain.
NOTE
Dispose of wet or moisten paper. It may cause
jamming in the printer
Islander PLUS Manual
94
To Next Page
Loading...
Need help?
General
