34 Replacing and Adding System Components
To remove the processor:
1 Open the locking lever on the processor socket by moving the lever
slightly out to the side, then lifting it straight up.
2 Lift the old processor straight up and out of the socket.
To install the new processor:
1 Hold the new processor over the empty processor socket and verify that
pin 1 on both the processor and the socket are aligned. Pin 1 is near the
marked corner of the processor.
2 Gently place the new processor into the socket.
Locking
lever
Processor
Pin 1
8506999.book Page 34 Friday, December 15, 2000 8:22 AM
To Next Page
Loading...
