Error messages 69
Error messages
This section lists common error messages that you may see. These messages
often indicate procedural errors such as an incorrect keystroke or a
write-protected diskette. Some messages, however, may indicate a problem
that requires you to consult the troubleshooting section of this manual.
Error message Description
GA20 Error An error occurred with Gate A20 when
switching to protected mode during the
memory test.
Pri Master HDD Error
Pri Slave HDD Error
Sec Master HDD Error
Sec Slave HDD Error
Could not read a sector from the
corresponding drive.
Pri Master Drive - ATAPI Incompatible
Pri Slave Drive - ATAPI Incompatible
Sec Master Drive - ATAPI Incompatible
Sec Slave Drive - ATAPI Incompatible
The corresponding drive is not an ATAPI
device. Run Setup to make sure the device is
selected correctly.
A: Drive Error No response from the diskette drive.
Cache Memory Bad An error occurred when testing the L2 cache.
The cache memory may be bad.
CMOS Battery Low The battery may be losing power. Replace the
battery soon.
CMOS Display Type Wrong The display type is different than what has
been stored in CMOS. Check Setup to make
sure the display type is correct.
CMOS Checksum Bad The CMOS checksum is incorrect. CMOS
memory may have been corrupted. Run Setup
to reset the values.
CMOS Settings Wrong CMOS values are not the same as the last
boot. These values have either been
corrupted or the battery has failed.
CMOS Date/Time Not Set The time and/or date values stored in CMOS
are invalid. Run Setup to set the correct
values.
8506999.book Page 69 Friday, December 15, 2000 8:22 AM
To Next Page
Loading...
Need help?
General
