28 Replacing and Adding System Components
Replacing the hard drive
To replace the hard drive:
1 Turn off the computer and disconnect the power cord, modem cable (if
installed), and all external peripheral devices.
2 Remove the cover. (See “Removing the cover” on page 17 and “Static
electricity precautions” on page 15.)
3 Locate the hard drive.
4 Remove the power and data cables from the back of the drive, noting
their locations and orientations. (You will reconnect these cables after you
install the new drive.)
5 Slide the locking clip toward the front of the chassis to release the drive
as shown by the arrow beside the unlock icon on the locking clip.
6 Lift the left edge of the drive, then pull the drive off of the pins on the
right side of the drive bay and lift it out of the chassis.
7 Place the old drive in an antistatic bag or container.
8 Set the drive jumpers on the new drive to the appropriate settings (refer
to your drive documentation for jumper settings).
Locking clip
8506999.book Page 28 Friday, December 15, 2000 8:22 AM
To Next Page
Loading...
