GATEXPERT SL500DC - Page 43

Instructions for SL500DC/SL800DC
www.gatexpertstore.com
38
twice, then L1 will be steady on.
3. Press “+” button twice to select start-up delay setting.  Indicator light L3 will be steady
on.
4. Press “SET” button once to enter into start-up delay setting.  Indicator lights L1-L3 will
show the current setting. (The default is L1)
5. Press “+” or “-” button to set the start-up delay time.  Indicator lights L1-L3 will show
the current setting. (Table 2 Start-up Delay Time)
6. Press “SET” button once to save and system will automatically exit.  The indicator
lights L1-L5 will be on in sequence, then all will flicker once and off.
B. Operation Graphic Illustration
Press “PROG”
for 3 sec.
L0 flicker once, L1
will be steady on
Press “PROG”
again for 3 sec.
L0 flicker twice, L1
will be steady on
Press “+” twice
L3 will be
steady on
Press “SET” once
Press “+” or “-” to set, LED
will show the setting value
Press “SET” once
Save and exit
PROG
PROG
SET
SET
L1-L5 will be on in
sequence then all
flicker once and off.