Puma III User Manual
CorelDRAW Plug-In A-3
Multiple Copies
It is suggested to select “Multiple Copies” when you would like to make several copies of one
image on your material to increase cutting accuracy.
Multiple Copies
No. of X Copies: The numbers of copies on X axis
No. of Y Copies: The numbers of copies on Y axis
Range: 1~50. (The more copies you make, the more time is
needed for data transmission.)
Numbers of X Copies * Numbers of Y Copies = The total
amount of image copies
Copies with outline：To show outlines of image graphics
The system will create the as shown in the picture below.
X axis
Y axis
Figure A3-11
Figure A3-12
To Next Page
Loading...
