GCC Technologies RX Series - 5 Automatic-Aligning System; Introduction

RX Series User Manual
Automatic-Aligning System
5-1
Chapter 5 Automatic-Aligning System
Please note that this chapter is only an instruction to AASII; for step-by-step instructions, please
refer to the following chapters: 08_A-3 CorelDraw Plug-In, 08_A-5 GreatCut, 08_A-6 Illustrator.
5.1 Introduction
The RX series cutting plotters feature a standard Automatic-Aligning System (AAS II) to
guarantee precise contour cutting quality by detecting the registration marks printed around the
graphic.
Notice
 Avoid any kind of light source horizontally illuminating the AAS module.
- PROHIBITED - ACCEPTABLE
 DO NOT take off the cover of AAS module while in operation.
- PROHIBITED