User Manual Druck DPI612
Page 67 of 105 [EN] English – 109M4017 Revision -
Figure 2-23 Source current with external loop power. (Range: 0 to 24 mA)
1. Set the applicable software options.
2. Complete the electrical connections and continue with
the measure or source operation.
3. Source only (Automation): Set the applicable output
value.
d. Example Procedure: Switch Test
Switch Test is only valid when a Pressure Function is selected.
Switch operation
When setting the Switch Test, the software automatically sets the
electrical channel to the switch test function.
Note: If there is an electrical function already selected it will
automatically be disabled. The display will show a screen message.
To Next Page
Loading...
