GE PROPRIETARY TO GE
D
IRECTION 5308917-100, REVISION 8 LOGIQ P3 SERVICE MANUAL
8-48 Section 8-4 - Mechanicals
8-4-10 MST BOARD ASSEMBLY ( P/N: 5315025-2 - LP3, 5388844-1 - LP3BT10)
SOM (P/N: 5398506 or 5267782-3 - LP3, 5398506 or 5267782-3 - LP3BT10)
This is a description on how to remove and replace the cable assembly of MST board and SOM.
8-4-10-1 Tools
• Common Phillips screwdrivers
8-4-10-2 Needed Manpower
• 1person, 15 minutes
8-4-10-3 Preparations
Shutdown the system and switch off the main Circuit Breaker at the bottom rear side of the system
8-4-10-4 Removal Procedure
1) Removal of all cable assembly from MST to TX as shown below Figure 8-54 on page 8-48
2) Use a screwdriver to remove the two screw holding the flexi cable to the MST board.
Refer Figure 8-54 on page 8-48
Figure 8-54 Removing Flexi cable of MST board
Flexi cable
LOGIQ P3
LOGIQ P3 BT
To Next Page
Loading...
