EasyManua.ls Logo

GE LOGIQ P6

GE LOGIQ P6
478 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GE HEALTHCARE
DIRECTION 5245279, REVISION 3 LOGIQ™ P6/P6 PRO SERVICE MANUAL
Section 8-3 - Software Loading Procedure 8 - 103
Section 8-3
Software Loading Procedure
8-3-1 General
This describes a full system software loading (Base Software Load Image + Arirang Application Load
Image) procedure.
Use this instruction when:
- Performing the HDD with new one (Base Software Load Image + Arirang Application Load Image)
- Performing the system revision-up (Application)
8-3-2 Parts Required
LOGIQ P6 Base Software DVD
LOGIQ P6 Application Software DVD
Blank CD-Rs ( for patient image backup) or DVDs
Service Dongle
NOTE: Patient Image Data will be deleted when all the drives are ghosted. Back up them on the CD-R
or DVD before starting software loading
NOTE: Insert the service dongle into ths service port located at the rear panel before installing the Base
System Software Load image
8-3-3 TimeRequired
Approximately 2hours

Table of Contents

Other manuals for GE LOGIQ P6

Related product manuals