Loading the software
LOGIQ V2/LOGIQ V1 – Basic Service Manual 7-29
5610739-100 English Rev.10
Software Upgrade Procedure (For R1.1.x) (continued)
5. If the Load the complete disk is selected.
• For R1.0.x, read the information in the Confirmation
dialogue box carefully and check the boxes before
Preset, Patient data and BIOS to confirm that the
requirements have been executed. Then input the
Installation Password: GEWuXiChina. Select Execute
to continue.
Figure 7-16. Input Password between R1.0.x
To Next Page
Loading...
