Standard PracticesInspection and Maintenance — GEK 107048
SP-17
Tool Name FigureQuantityApplication
Shackle, Anchor Used for Lifting Inlet Duct Components 4 2-33
Charging Hose Assembly
and Precharging Gauge
Device
Used for Checking and Charging Hydraulic
Accumulators
1 2-34
Plate, Flushing Assembly Used for Flushing Hydraulic Control Oil
Lines
1 2-35
Pliers, Hose Clamp
Atomizing Air
Compressor
Used for Removing the Retaining Ring From
the Atomizing Air Compressor Quill Shaft
1 2-36
Tool, Insertion and
Extraction
Used for Disassembly and Reassembly of
Cable Connections
1 2-37
Tubing, Plastic Used for Bleeding Air From Fuel System
Filters
1 2-38
Insert, Tubing Used with Plastic Tubing and Male
Connector
10 2-38
Connector, Tube Male Used to Connect Plastic Tubing and Insert to
Fuel System Filters
10 2-39
To Next Page
Loading...
