Standard PracticesInspection and Maintenance — GEK 107048
SP-57
MS-6001B DLN-1 — Major Inspection Recommended Spare Parts (Cont’d)
Recommended
Quantity
ENCLOSURE TO BASE ARRANGEMENT (ML1605)
Note: The list of gaskets, nuts and bolts shown below with varying quantities,
indicates that there are different sizes required. Using the applicable
enclosure to base arrangement drawing, the user should procure the
gasketing quantities shown and approximately 20% of the hardware
quantities shown to cover any hardware which may not be reusable.
**1. Gasket, Access Cover Plate 1
2. Seal, Rubber Strip 2
3. Strip 1
4. Seal, rubber Strip 1
**5. Gasket, Panel 1
**6. Gasket, Silicone 1
**7. Gasket, Dryback Adhesive 1
**8. Gasket, Asbestos 1
9. Cement AR
10. Caulking AR
11. Adhesive AR
**12. Gasket 56
**13. Gasket, Duct 1
**14. Gasket, Duct 1
15. Screw, Machine Round Head *5
16. Washer, Plain Regular *2
17. Bolt, Hex Head *2
18. Washer, Plain Regular *18*
19. Nut, Hexagon *3
20. Bolt, Hex Head *14*
21. Washer, Rubber *16*
22. Bolt, Hex Head *3
23. Bolt, Hex Head *8
24. Bolt, Hex Head *2
25. Bolt, Hex Head *12*
26. Washer, Plain Wide *12*
27. Washer, Flat *7
28. Washer, Plain Regular *7
29. Bolt, Hex Head *12*
To Next Page
