5–10 850 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL
COMMUNICATIONS CHAPTER 5: STATUS
COMMS NOT VALIDATED OK
Range: NO, YES
Default: NO
COMMS NOT VALIDATED DONE
Range: YES, NO
Default: YES
COMMS VALIDATED OK
Range: YES, NO
Default: YES
COMMS VALIDATED DONE
Range: YES, NO
Default: YES
MAIN NOT VALIDATED OK
Range: NO, YES
Default: NO
MAIN NOT VALIDATED DONE
Range: YES, NO
Default: YES
MAIN VALIDATED OK
Range: YES, NO
Default: YES
MAIN VALIDATED DONE
Range: YES, NO
Default: YES
NOT RUNNING.ERROR CID
Range: NO, YES
Default: NO
RUNNING.DEFAULT CID
Range: NO, YES
Default: NO
RUNNING.SAVING CID TO FLASH
Range: NO, YES
Default: NO
CID HANDLING DONE
Range: YES, NO
Default: YES
NUMBER OF CONNECTED CLIENTS
Default: 0
CLIENT 1(8) IP ADDRESS
Range: 0, 0XFFFFFFFF
Default: 0
ACTIVITY STATUS
The communication state for each enabled communication type is shown by its value. The
main CPU and Comms software sets/resets the active bits for all enabled communication
types. The communication state bits are not latched.
Path: Status > Communications > Activity Status
To Next Page
Loading...
