GEK-113032A W650 Wind Generator Protection System 5-27
5 SETTINGS 5.4 PROTECTION ELEMENTS
5
The distribution of protection elements in tabled groups is described in Table 5–28:
Table 5–28: DISTRIBUTION OF PROTECTION ELEMENTS
The settings used for setting table management are located in Setpoint >Control Elements > Setting Group:
Table 5–29: SETTING GROUP SETTINGS
setting Group settings are as follows:
Function: Possible values are: [DISABLED – ENABLED]
When this setting is disabled, the relay is working in single setting group mode, with all the available protection elements
working at the same time. If this function is enabled, the setting groups will be enabled, and only the setting group indicated
by the Active Group setting will be active.
Active group: Possible values are 1, 2, 3 or 4.
The setting group selected by default is setting Group 1. This setting indicates which setting group is active (for this
purpose, the previous setting must be set as ENABLED)
The Relay incorporates several signals associated to the Protection elements grouping in tables. First, signals that indicate
the group activation:
GROUP 1 ACT ON This signal produces the activation of setting group 1
GROUP 2 ACT ON This signal produces the activation of setting group 2
TABLE 1 TABLE 2 TABLE 3 TABLE 4
1x50PH 1x50PH 1x50PH
1x50PL 1x50PL 1x50PL
1x50N 1x50N 1x50N
1x50G 1x50G 1x50G
1x50SG 1x50SG 1x50SG
1x51PH 1x51PH 1x51PH
1x51PL 1x51PL 1x51PL
1x51N 1x51N 1x51N
1x51G 1x51G 1x51G
1x51SG 1x51SG 1x51SG
1x46P 1x46P 1x46P
1x67P 1x67P 1x67P
1x67N 1x67N 1x67N
1x67G 1x67G 1x67G
1x67SG 1x67SG 1x67SG
1x27P 1x27P 1x27P 1x27P
1x59P 1x59P 1x59P 1x59P
1x59NH 1x59NH 1x59NH
1x59NL 1x59NL 1x59NL
1x59X 1x59X 1x59X
1x27X 1x27X 1x27X
1x32 1x32 1x32 1x32
1x81U 1x81U 1x81U 1x81U
1x81O 1x81O 1x81O 1x81O
1x60 1x60 1x60
SETPOINT > CONTROL ELEMENTS > SETTING GROUP
Setting Description Name Default Value Step Range
Setting Grouping Permission Function DISABLED N/A [DISABLED – ENABLED]
Active Group Active Group GROUP 1 N/A [GROUP 1 – GROUP 2 – GROUP 3 – GROUP 4]
Snapshot Event generation Snapshot Events ENABLED N/A [DISABLED – ENABLED]
To Next Page
Loading...
