GE Multilin W650 - Control Settings for Inputs;Outputs

GEK-113032A W650 Wind Generator Protection System 5-89
5 SETTINGS 5.6 INPUTS/OUTPUTS
5
5.6.2 CONTROL SETTINGS FOR INPUTS/OUTPUTS
Configuration of settings relative to inputs and outputs can only be accessed through the EnerVista 650 Setup
software, and not via the HMI. For this purpose, the user must access Setpoint > Inputs/Outputs > Contact I/O > Board
X, being X the corresponding I/O board.
settings relative to I/O boards are described in Table 5–77:
Table 5–77: I/O BOARD SETTINGS
The snapshot event setting enables or disables the snapshot event generation for this element.
Being:
X F or G, the I/O board name, depending on the Relay model.
SETPOINT > INPUTS/OUTPUTS > CONTACT I/O >
BOARD F > BOARD G
SETTING DESCRIPTION NAME DEFAULT
VALUE
STE
P
RANGE
I/O board type (available only for CIO modules) I/O Board Type_H NONE N/A [NONE,
16 INP + 8OUT,
8 INP + 8OUT + SUPV
32 INP
16 INP + 8 ANA]
Input activation voltage threshold
Group A
Voltage Threshold A_X 80 1 V [20 : 230]
Input activation voltage threshold
Group B, C and D
Voltage Threshold B_X 80 1 V [20 : 230]
Debounce time for Group A Debounce Time A_X 15 1 ms [1 : 50]
Debounce time for Group B, C and D Debounce Time B_X 15 1 ms [1 : 50]
Input type Input Type_X_CCY (CCY) POSITIVE N/A [POSITIVE-EDGE,
NEGATIVE-EDGE,
POSITIVE,
NEGATIVE]
Input signal time delay Delay Input Time_X_CCY (CCY) 0 1 ms [0 : 60000]
Output logic type Output Logic_X_0Z POSITIVE N/A [POSITIVE,
NEGATIVE]
Output type Output Type_X_0Z NORMAL N/A [NORMAL,
PULSE,
LATCH]
Output pulse length Pulse Output Time_X_0Z 10000 1 ms [0 : 60000]
Analog Inputs Range Range_X-02 None N/A [NONE,
-1 to 0mA,
0 to 1 mA,
-1 to 1 mA,
0 to 5 mA,
0 to 10 mA]
Minimum Value Min_Value_X_0X 0.00 0.01 [ -9999.99 : 9999.99]
Maximum Value Max_Value_X_0X 0.00 0.01 [ -9999.99 : 9999.99]
Snapshot event generation Snapshot Events ENABLED N/A [DISABLED – ENABLED]