GEK-113032A W650 Wind Generator Protection System D-7
APPENDIX D D.5 IEC 60870-5-104 POINT LIST
D
Table D–1: OPERATIONS:
Table D–2: CLOCK SYNCHRONIZATION:
The date in the answer is the same as the received in the command.
The relay date is synchronized after performing this command.
Table D–3: RESET OF PROCESS
QRP_RESET_GRAL: General reset of process.
Table D–4: ACQUISITION OF TRANSMISSION DELAY:
The date in the answer is the same as the received in the command.
OPERATIONS
POINT DESCRIPTION
C_SC_NA_1
3000 – 3011 Command OFF
3000 – 3011 Command ON
CLOCK SYNCHRONIZATION
POINT DESCRIPTION
C_SC_NA_1
0 Set Date
RESET OF PROCESS
POINT DESCRIPTION
C_RP_NA_1
0 Reset of Process
DELAY ADQUISITION
POINT DESCRIPTION
C_CS_NA_1
0 Delay Acquisition
To Next Page
