Geeetech A30 - Move

9
1) When the printer is running with a TF card or connected with a computer, clicking
on the [Home] menu is disabled. This situation also applies to the [Disable] status of the
stepper motors.
2) When the printer is idle, you can click to home X/Y/Z
axis respectively. Besides, it is efficient to click to home the three axises
simultaneously.
3) Choose the button to get to the [Move] interface.
2.2.2 Move
1) When the printer is running with a TF card or connected with a computer, clicking
on the [Move] menu is disabled. This situation also applies to the [Disable] status of the