Geeetech A30 - Stand-Alone Printing with a TF Card

27
4) The last step is to click [Run job] to start your printing journey.
After clicking [Run job], Geeetech A30 will enter printing mode. The printer begins to
work as soon the heating process is over.
4.2 Stand-alone Printing with a TF Card
Geeetech A30 can run stand-alone with a TF card, untethered to your computer. All you
need to do is save 3D models in the TF card for printing. Here are the detailed procedures.
1) After slicing, please click ―Save job‖ to save the file for direct printing