Geeetech A30 User Manual

37
4. Then you will see the following interface, showing that the printer is off-line.
That‘s the whole binding process. In the next part, we will finish the Wi-Fi configurations
step by step. Be patient~
4.3.3 Wi-Fi Configurations
Detailed configuration procedures for Wi-Fi connectivity are as follows:
Step 1. In Wi-Fi setting interface on the control panel, choose Wi-Fi button
to enter Wi-Fi interface, as shown in the picture below.

Geeetech A30 Specifications

General

Build Volume	320 x 320 x 420 mm
Nozzle Diameter	0.4 mm
Filament Diameter	1.75 mm
Connectivity	USB, SD card
Frame Material	Aluminum
Printing Technology	FDM (Fused Deposition Modeling)
Heated Bed	Yes
Supported Filaments	PLA, ABS, PETG
Display	LCD
Power Supply	24V
Bed Temperature	Up to 110°C
Nozzle Temperature	Up to 250°C
Printing Platform	Removable glass platform