62
Click ‗ok‘ and ‗Close‘ on the windows to complete the firmware upgrade.
6.3 Fail to Complete the Wi-Fi Configuration
Tips:
1) At ④, if the Wi-Fi built in the printer could be detected, please exit from Set mode,
turn the button Wi-Fi off and turn it on again. Enter the Set mode to continue the
configuration.
2) At ⑥, enter the password and click ―[OK]”. If a prompt “Not connect with Printer
Wi-Fi “pops up, please manually connect with Printer Wi-Fi or again make the configuration.
To Next Page
Loading...
