54
When the extruder reaches its target temperature, you can start to print.
Note: 1. If necessary, please give 3D Touch a self-test. Click the
buttons to test if 3D touch could work normally. Whenever there is any
obstruction, fault or even dirt on 3D touch, it will release an alarm. In this case, please
click the button to stop it.
2. If the probe can‘t be pushed down or the LED light keeps flickering, please click the
/ / button to make a modification. When the
LED light keeps flickering, it is necessary to disable the alarm.
3. If the first layer is unsatisfactory, please adjust the Z offset in an appropriate way.
6. FAQ
As your deepening acquaintance with Geeetech A30 3D printer, you may meet different
problems during the printing. The following are simple guidelines to help you easily solve
some issues. If you need more helps, please visit
https://www.geeetech.com/wiki/index.php/Print_Quality_Troubleshooting_Guide.
6.1 About Printing Problem
6.1.1 Not Extruding at the Beginning of Print
To Next Page
Loading...
