SHENZHEN GETECH TECHNOLOGY CO,.LTD
1. Check Power Supply
The power supply unit and control board of Me Creator 2 are installed in the bottom of the printer, saving
space, as well as lowering the gravity center of the printer to provide stable support for printing. The printer
uses DC12V, 29A power supply, choose 110V or 220V according to national power using standard. Please
make sure that the voltage of the power supply conforms to current national power using standard. You can
check the power identifier on the shell of the printer to confirm it.
2. Software Resources
2.1 Repetier-Host
The Repetier-Host is a simple to use host software, which is be compatible with most firmwares around. You
can add and position your STL files on the simulated print bed and slice them all together. For slicing you
can use the built-in Slic3r slicer. Just call "Slice & Load" and the job gets delegated to the current slicer,
showing its output in the log window.
Download the Repetier host V 1.6.0 here.
For detailed information of Repetier Host please refer to our wiki.
For detailed using methods of the slicing software, slic3r, which comes with Repetier Host, please also refer
to our wiki.
2.2 Arduino IDE
The open-source Arduino Software (IDE) makes it easy to write code and upload it to the board. It runs on
Windows, Mac OS X, and Linux. The environment is written in Java and based on Processing and other
open-source software.
This software can be used with any Arduino board.
Download Arduino-1.0.1- here.
2.3 Firmware
MeCreator 2 uses GT2560 control board, you can download the corresponding firmware here.
To know how to upload the firmware, please refer to FAQ.
To Next Page
Loading...
Need help?
General
