SHENZHEN GETECH TECHNOLOGY CO,.LTD
6. Build platform leveling
Before printing, please check whether the moving path of the extruder is parallel with the heatbed or not,
which is called leveling. We need make sure the distances from the nozzle of the extruder to the four
cornered of the heatbed are the same, and only in this way can we get good printing quality.
You can check the level of the heated platform by using a piece of paper to check the gap under the nozzle.
It’s best to do this with the platform heated to account for any change due to expansion.
Put the paper under the nozzle near one of the front screws and raise the bed .1mm at a time using the
manual controls in the software interface while sliding the paper back and forth. Stop when you feel the
nozzle start to grab a little bit.
Watch the video here.
To Next Page
Loading...
Need help?
General
