SHENZHEN GETECH TECHNOLOGY CO,.LTD
At the same time, set the diameter of the print head as 0.4mm. (input the actual diameter of your printer)
7.4 Other parameters
Except for above settings, parameters like speed are also important to the printing effect, which requires
your long time using experience of 3D printing. Here we give you a reference setting, please download the
attachment config.ini. You can import it into slic3r according to the following steps.
Note: the configuration uses 1.75mm PLA filament and 0.4mm nozzle diameter, and it slices with slic3r
engine which is built-in in Repetier host 1.6.0.
Open slic3r>File>Load Config：
To Next Page
Loading...
