EasyManuals Logo

Geeetech ME CREATOR 2 User Manual

Geeetech ME CREATOR 2
69 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
SHENZHEN GETECH TECHNOLOGY CO,.LTD
13
PortGet the printer connected to the port of computer, which is corresponding to the USB Serial Port
in the Device manager.
Baud Rate: Corresponding to the Baud Rate in firmware. Generally it is set as 250000.
Note: If the operating system is Mac OS, please set the baud rate of the firmware and Repetier Host as
115200.
Open the firmware in Arduino, and modify the baud rate to 115200 in Configuration.h. Shown as
following picture.
After modification, re-upload the firmware:

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Geeetech ME CREATOR 2 and is the answer not in the manual?

Geeetech ME CREATOR 2 Specifications

General IconGeneral
BrandGeeetech
ModelME CREATOR 2
Category3D Printers
LanguageEnglish

Related product manuals