PRINTED IN U.S.A. 23 913287/BP0808
GUARDS AND SHIELDS
Whenever possible and without affecting machine
operation, guards and shields are used to protect poten-
tially hazardous areas. In many places, decals are also
provided to warn of potential hazards and to display
special operating procedures.
WARNING
Read and thoroughly understand all safety
decals on the Telescopic Handler BEFORE
operating it. DO NOT operate the machine
unless all factory-installed guards and shields
are properly secured in place.
CAUTION
Become familiar with and know how to use
ALL safety devices and controls on the
Telescopic Handler BEFORE operating it.
Know how to stop the machine operation
BEFORE operating it. This Gehl machine is
designed and intended to be used ONLY with
a Gehl Company attachment tool, or a Gehl
Company approved accessory or referral
attachment tool. Gehl Company cannot be
responsible for product safety if the machine
is used with an unapproved attachment tool.
Chapter 5
INDICATORS AND CONTROLS
Left Bank
Switches
Travel Range
and Direction
Lever
Steering
Wheel
Throttle Pedal
Brake Pedal
Console
Tilt Lever
Outrigger
Switches
(if equipped)
Key
Switch
Joystick
Boom
Controller
Start
Button
Engine Emergency
Override Switch
Right Bank
Switches
Load Zone
Charts
Indicators and
Gauges Panel
Horn
Button
Operator Compartment Indicators and Controls Locations
Frame Level
Switch
Courtesy of Crane.Market
To Next Page
Loading...
Need help?
General
