913287/BP0808 46 PRINTED IN U.S.A.
3. The incline of the ramps MUST be less than 15
degrees (ramp length MUST be at least 16 feet
(4.9 m) long).
4. Ramp width MUST be at least 1-1/2 times the tire
width.
5. Block the front and rear of the tires on the truck
or trailer. Engage the parking brake.
6. Position the machine (with the boom facing
toward the front of the truck or trailer) so that it is
straight in line with the ramps.
7. Slowly (at the lowest engine speed possible) and
carefully drive the machine up the ramps.
8. Secure the machine to the bed of the truck or trail-
er. Tie-down slots are provided on the front and
rear sides of the frame structure.
Unloading Machine Using Ramps
NOTE: A matched pair of ramps is required.
Repeat steps 1 through 5 and proceed as follows to
unload the machine:
6. Remove the tie-down chains/cables.
7. If necessary, adjust the machine so that the wheels
are in line and centered with the ramps.
8. Slowly (at the lowest engine speed possible) and
carefully drive the machine down the ramps.
WARNING
NEVER transport the machine with the boom
raised or extended. BE SURE to secure the
machine to the truck or trailer bed using
chains and binders or steel cables, to prevent
any movement while transporting.
WARNING
NEVER adjust travel direction (even slightly)
while traveling on the ramps. Instead, back
down off the ramps, and then realign the
machine with the ramps.
THEFT DETERRENTS
Gehl Company has recorded all major component part
numbers and serial numbers. Users should take as
many of the following actions as possible to discour-
age theft, to aid in the recovery in the event that the
machine is stolen, and to reduce vandalism:
1. Remove keys from unattended machines.
2. Attach, secure, and lock all anti-vandalism and
anti-theft devices on the machine.
3. Lock doors of cabs when not in use.
4. Inspect the gates and fences of the vehicle storage
yard. If possible, keep machines in well-lighted
areas. Ask the local law enforcement agency to
make frequent checks around the storage and
work sites, especially at night, during weekends,
and on holidays.
5. Report any theft to your dealer and insurance
company. Provide the model and serial numbers.
Request that your dealer forward this information
to Gehl Company.
Courtesy of Crane.Market
To Next Page
Loading...
Need help?
General
