PRINTED IN U.S.A. 65 913287/BP0808
During Storage
1. About once each month, connect the battery and,
before starting the engine, check all fluid levels to
make sure they are at the proper level.
2. Start the engine and allow it to run until it warms
up. Then move the machine a short distance to
help relubricate the internal parts. Run the engine
until the battery has a chance to recharge, and
then shut it off.
IMPORTANT: If it is desired to operate the
hydraulic cylinders at this time, BE SURE to wipe
the protective grease (and any adhering dirt) from
the cylinder rods prior to starting the engine. After
operating, if the machine is to be returned to stor-
age, re-coat the cylinder rods with grease.
After Storage
After removing the machine from storage and
BEFORE operating it, perform the following:
1. Change engine oil and filter to remove any con-
densation and residues.
2. Wipe off grease from cylinder rods.
3. Lubricate ALL grease fittings.
4. Follow the starting and warm-up procedures out-
lined in the Operation and Adjustments chapter of
this manual.
Courtesy of Crane.Market
To Next Page
Loading...
Need help?
General
