913287/BP0808 66 PRINTED IN U.S.A.
Problem
PWP System switch lamp flash-
es when switch is pressed to
“ON.”
Parking brake did not engage
when PWP System switch was
pressed to “ON.”
Carriage tilt and auxiliary func-
tions continue operating when
the PWP System switch is
pressed to “ON.”
Transmission does not remain
de-clutched when shifted into
“Forward” or “Reverse” when
the PWP switch is “ON.”
Boom control functions do not
operate.
PWP System switch lamp flash-
es when switch is turned “OFF.”
Parking brake switch lamp stays
“ON” when PWP System switch
is “OFF.”
Possible Cause
PWP System is not activated.
Machine is not level.
PWP System remote shutdown
switch is disengaged.
40’ and 44’ models:
PWP System remote shutdown
switch is not plugged into the
connector at the end of the
boom.
55’ model:
Low or dead batteries in PWP
System remote shutdown switch.
PWP System level sensor
unplugged or faulty.
PWP System is not de-activated.
Remedy
With PWP System switch “ON,”
apply service brakes for three
seconds until PWP switch lamp
is lit continuously.
Level the machine.
Engage the PWP System remote
shutdown switch.
Plug in and engage the PWP
System remote shutdown switch.
Replace batteries and engage
the PWP System remote shut-
down switch.
Contact your Gehl dealer for
assistance.
With engine running, apply ser-
vice brakes for three seconds
until PWP switch lamp goes off.
PWP SYSTEM OPERATIONAL TROUBLESHOOTING
Courtesy of Crane.Market
To Next Page
Loading...
Need help?
General
