PRINTED IN U.S.A. 15 913287/BP0808
SAFETY
Wireless Remote Battery Replacement
1. Remove the four screws from the cover of the
wireless remote.
2. Open the cover to gain access to the batteries.
3. Remove the batteries from their holders.
4. Install the replacement batteries in the holder tak-
ing care to position the battery terminals as shown
in the diagram at the bottom of the battery holder.
5. Replace the cover and install the screws to secure
the cover in place.
Work Platform Design Requirements (Per
ANSI/ITSDF B56.6-2005, Sec. 8.24)
1. A platform floor having a slip-resistant surface
located not more than 8 inches (200 mm) above
the normal load supporting surface of the forks.
2. Floor dimensions which shall not exceed two
times the load center distance of 24 inches (610
mm) listed on the forklift nameplate, measured
parallel to the longitudinal center plane of the
truck, nor have a width greater than the overall
width of the forklift [measured across the load-
bearing tires plus 10 inches (250 mm) on either
side]. Minimum space for each person on the plat-
form shall not be less than 18 inches (450 mm) in
either direction.
3. A 4 inch (100 mm) minimum height toe plate,
which may be omitted at the access opening.
4. An overhead protective device, when requested
by the user.
5. Protection for personnel in their normal working
position on the platform from moving parts of the
forklift that may present a hazard.
6. Information prominently indicated on the plat-
form:
a. maximum work load including personnel and
equipment, and
b. weight of empty platform.
7. Means so that the platform can only be centered
laterally on the forklift, and retained against the
vertical face of the forks, carriage, or lifting
mechanism.
8. A means to securely attach the platform to the lift-
ing mechanism, and to prevent the platform from
inadvertently pivoting.
9. Restraining means such as a guardrail or a means
for securing personnel such as a body harness and
lanyard. A guardrail or similar structure shall have
a nominal height to the platform floor of 42 inch-
es (1066 mm) around its upper periphery and
include a midrail. It may be hinged, removable, or
of chains, and used to provide an access opening
if proper positioning is easily accomplished and a
secure condition is discernable. Such restraining
means shall be capable of withstanding a concen-
trated horizontal force of 200 lbs. (890 N) applied
at the point of least resistance without permanent
deformation. A body harness and lanyard is to
have an attachment point provided overhead for
freedom of movement, and its length is to limit
free-fall to 5 feet (1500 mm) measured from the
point of attachment to the operator. The complete
system shall be capable of withstanding three
consecutive drop tests to simulate a 250-pound
(113 kg) person falling 6 feet (1800 mm) without
allowing the test weight to fall free to the ground.
A deceleration device may be included.
Wireless Remote Shutdown Switch
on 55’ Models
PWP
Remote
Shutdown
Switch
Courtesy of Crane.Market
To Next Page
Loading...
Need help?
General
