50950106/AP0313 19
CHAPTER 3
CONTROLS AND SAFETY EQUIPMENT
Become familiar with and know how to use all
safety devices and controls on the skid-steer
loader before operating it. Know how to stop loader operation
before starting it. This Gehl loader is designed and intended to be
used only with Gehl attachments or Manitou Americas-approved
referral attachments or accessories. Manitou Americas cannot be
responsible for operator safety if the loader is used with non-
approved attachments.
Guards and Shields
Whenever possible and without affecting loader operation, guards and shields are
provided to protect against potentially hazardous areas. In many places, safety
decals are also provided to warn of potential hazards and/or to display special
operating procedures.
Read and thoroughly understand all safety
decals on the loader before operating it. Do
not operate the loader unless all factory-installed guards and
shields are properly secured in place.
Operator Restraint Bar
Lower the operator restraint bar after entering the operator’s compartment and
sitting in the seat. The restraint bar is securely anchored to the ROPS/FOPS. The
operator must be seated with the restraint bar in its lowered position to start or
operate the skid-steer loader. Refer to Safety Interlock System on page 20 for
more information.
Dual Joystick and Hand/Foot controlled loaders are equipped with a restraint bar
that provides fore-aft adjustment, allowing the operator to determine the most
comfortable position for the restraint bar. The right and left portions of the
restraint bar system can be adjusted independent of one another by pushing the
locking lever on the lower inside of either pad. The restraint pads can then be
adjusted to the desired position. The restraint pads lock in place when the locking
lever is released.
Never defeat the operator restraint bar or seat
switch electrically or mechanically. Always
wear the seatbelt.
To Next Page
Loading...
Need help?
General
