Gehl R190 - SPECIFICATIONS; Loader Model Specifications

50950106/AP0313 103
CHAPTER 7
MAINTENANCE
This Maintenance Interval chart was developed to match the Service chapter of this
manual. Detailed information on each service procedure is in the
Service chapter. A
Maintenance Log follows this chart for recording maintenance performed. Recording
10-hour (or daily) service intervals is impractical and is not recommended.
Important: Under severe operating conditions, more frequent service than the
recommended intervals may be required. You must decide, based on your use, if
your operation requires more frequent service.
Service Procedure
Maximum Interval
10 Hours
(or Daily)
50
Hours
250
Hours
500 Hours
(or Yearly)
Remove Foreign Material (page 72)

Check Engine Air Cleaner Restriction Indicator
(page 77)

Check Engine Oil Level (page 80)

Check Hydraulic Oil Level (page 87)

Check Tire Pressures (page 91)

Grease Hitch, Hitch-related Cylinder Pivots
and Latch Pins (page 73)

Check Bucket Cutting Edge (page 88)

Test Safety Interlock System (page 20)

Check Coolant Level (page 89)

Clean Cooling System (page 89)

Grease Lift Arm Pins (page 73)

Check Drive Chain Tension (page 76)

Check Wheel Nuts Torque (page 88)

Check Oil Level in Chaincases (page 75)

Check Alternator/Fan Belt Tensions (page 88)

Change Engine Oil and Filter (page 80)

Change Hydraulic Oil Filter (page 87)

Check Battery (page 94)

Check Engine Mounting Hardware (page 80)

Change Fuel Filter (page 81)

Change Hydraulic Oil (page 88)

Check and Drain Water Separator (page 81)

Change Chaincase Oil (page 75)

Change Engine Coolant (page 90)

 Perform the initial procedure at 2 hours then at “” intervals.
 Perform the initial procedure at 50 hours then at “” or “” intervals.
 Severe operating conditions.
 Perform the procedure at 1000 hours.