Gehl R190 User Manual

50950106/AP0313 95
CHAPTER 6
TROUBLESHOOTING
Electrical System
Problem Possible Cause Remedy
Entire electrical
system does not
function.
Battery disconnect switch is
in OFF position.
Turn battery disconnect
switch to ON.
Main wiring harness
connectors at rear of ROPS/
FOPS not properly plugged in.
Check main harness
connectors.
Faulty keyswitch. Replace keyswitch.
15 amp fuse blown (key
switch).
Replace keyswitch.
Battery terminals or cables
loose or corroded.
Clean battery terminals and
cables and retighten them.
Battery is faulty. Test battery, replace as
needed.
No instrument panel
lamps with keyswitch
turned to “ON.”
Fuse has blown. Replace fuse.
Main wiring harness
connectors at rear of ROPS/
FOPS not properly plugged in.
Check main harness
connectors.
Battery terminals or cables
are loose or corroded.
Clean battery terminals and
cables and retighten them.
Starter will not
engage when key is
turned to START.
Battery terminal or cables
loose or corroded.
Clean terminal, cables and
retighten
Battery discharged or
defective.
Recharge or replace battery.
Seat or restraint bar switch
malfunctioning or not
actuated.
Contact your dealer.
Ignition wiring, seat switch,
restraint bar switch, etc.
loose or disconnected.
Check wiring for poor
connections, broken leads;
repair wiring or connection.
Start safety relay malfunction
located in fuse panel.
Verify proper operation.
Starter solenoid not
functioning.
Contact your dealer.
Starter relay malfunctioning. Verify relay is working
properly, replace.
Starter or pinion faulty. Remove starter; repair/
replace as needed.
Engine fault code: (E-ECU
will not allow crank if certain
faults are present).
Contact your dealer.

Gehl R190 Specifications

General

Rated Operating Capacity	1, 900 lbs
Tipping Load	3, 800 lbs
Engine Make	Yanmar
Travel Speed	7.5 mph
Auxiliary Hydraulic Flow	18.5 gpm
Hydraulic System Flow	18.5 gpm