34 50950106/AP0313
Information Center Electronic Display (cont.)
Engine Stop
The engine stop icon is used to notify the operator that the
engine is in “backup” or “limp” mode. See the backup mode
description on page 60 for more details.
Engine Water Temp Overheat Warning
The engine water temperature overheat icon is used to notify
the operator of high engine coolant temperature. The operator
should take action to reduce load on the engine and allow the
engine to cool.
DPF (Diesel Particulate Filter) Service
The DPF service icon is used to notify the operator that the
engine is in an emergency condition where ash cleaning is
required. See the ash cleaning mode description on page 60
for more details.
Elevated EGT (Exhaust Gas Temperature)
The EGT icon is used to notify the operator of high exhaust
temperatures during an active reset/stationary regeneration.
Parking Brake
The parking brake icon is used to remind the operator that the
parking brake switch must be engaged prior to a stationary
regeneration.
DPF Regeneration Acknowledgement
The DPF regeneration acknowledgement icon is
used to notify the operator that the E-ECU has
received the stationary regeneration request. It is
used to prompt the operator to start a stationary
regeneration request or to allow a reset regeneration.
To Next Page
Loading...
