38 50950106/AP0313
Lift/Tilt Control
Moving the lift arm and tilting the attachment are accomplished by movement of
the right joystick. To raise the lift arm, pull the control straight rearward; to
lower the lift arm, push the control straight forward. To tilt the attachment for-
ward and downward, move the control to the right; to tilt the attachment up
and back, move the control to the left.
Note: The speed of the lift/tilt motion is directly proportional to the amount of
joystick movement and engine speed.
To place the lift arm into the “float” position, push and hold the left button on the
right joystick. This mode allows the lowered lift arm to follow the ground con-
tour while traveling over changing ground conditions. An indicator lamp in the
indicator and warning lamp display will blink when float is activated.
Never push the float control button with the
attachment raised, because this will cause the
lift arm to lower very rapidly.
Releasing the float button will cancel the float mode if the button was pressed
less than five seconds. If the float mode button is pressed longer than five sec-
onds, the float feature will remain on and the float indicator lamp will remain lit
until the button is pressed again or the machine is turned off.
To Next Page
Loading...
