50950106/AP0313 67
CHAPTER 5
SERVICE
Before servicing the machine, unless
expressly instructed to the contrary, exercise
the MANDATORY SAFETY SHUTDOWN PROCEDURE (page 6).
After service has been performed, be sure to restore all guards,
shields and covers to their original positions before resuming
operation.
This
Service
chapter details procedures for performing routine maintenance checks,
adjustments and replacements. Most procedures are referred to in the
Troubleshooting
and
Maintenance
chapters of this manual. Refer to the
Maintenance Interval Chart
(page 103) for service intervals. Refer to the separate engine manual for engine-
related adjustments, lubrication and service procedures.
Note: All service procedures, except those described under the Dealer Services
topic are owner-operator responsibilities.
Important: Always dispose of waste lubricating oils and hydraulic fluids
according to local regulations or take to a recycling center for disposal. Do not
pour onto the ground or down the drain.
Dealer Services
The following areas of component service, replacement and adjustments require
special tools and knowledge for proper servicing and should be performed only
by your authorized Gehl skid-steer loader dealer: hydrostatic drive components,
hydraulic system pumps, valves, hydraulic cylinders, electrical components
(other than battery, fuses or relays).
Sliding Side Window Removal Procedure
The sliding side windows inside the
ROPS/FOPS can be removed for
cleaning. To begin, open the cab door and
slide one of the side windows to the rear.
Using a non-marring tool, separate the
front plastic rail underneath the sliding
window from the window frame. Pull the
plastic rail forward until it releases from
the window frame. Then slide the side
window to the front and separate the rear
plastic rail from the window frame in the
same manner, pulling the rail rearward to
release it from the window frame. The
sliding side window may now be removed
from the ROPS/FOPS. To reinstall the
window, reverse the removal steps.
Figure 30 Rail removed from
window frame.
To Next Page
Loading...
Need help?
General
