Gehl R190 - Page 70

66 50950106/AP0313
DPF Regen Flowcharts, cont.
What happens if a Staonary
Regen Procedure is not performed
within 10 hours?
DPF SWITCH
Keeping the DPF switch in the CANCEL
posion for more than 10 hours
OR
Keeping the DPF switch in the center
AUTO posion for more than 10 hours
automacally transfers the E-ECU to
Backup mode.
If a Stationary Regen Mode is requested by the ENGINE— ECU
DPF SWITCH
When these icons are acve, the E-ECU is requesng a Staonary Regen.
DPF SWITCH
DPF REGEN ACKNOWLEDGE
(Electronic Display)
See Staonary Regen Procedure
for complete details.
DPF SWITCH
Press and hold Staonary Regen
Request switch for three seconds.
These icons will appear on
the Electronic display during
the Staonary Regen mode.
E– ECU returns to
Normal Operaon
A Staonary Regen Procedure is
required within 10 hours.
Staonary Regen
Backup Mode (Limp Mode)