72 50950106/AP0313
Adjustments
Control Handles
The control handles do not require routine adjustment. Refer to the Service
Manual for the initial setup procedure.
Removing Foreign Material
The loader should be cleared daily of dirt and other foreign materials in the
following areas:
• around the lift cylinders
• at the front of the loader
• on the hitch, especially around tilt cylinder
• around the hydraulic oil reservoir breather
• in the engine compartment
• in the operator’s compartment
Important: Build-up of foreign materials in these areas can interfere with the
operation of the loader, cause component damage or become a fire hazard.
To Next Page
Loading...
