36 50950106/AP0313
Right Panel
1. Information Center Electronic Dis-
play – See page 29.
2. Parking Brake Switch – Used to manu-
ally apply the parking brake. Lights
when the parking brake is applied.
3. Front Wiper/Washer (optional)
4. Rear Wiper/Washer (optional)
5. DPF (Diesel Particulate Filter) Regen-
eration Switch – The DPF switch oper-
ates in this manner:
Regen Auto: The neutral center AUTO posi-
tion of the switch allows the E-ECU to per-
form low-level DPF regeneration as
required, without operator input.
Regen Request (Allow): The left side of the
switch is a momentary switch used for
starting a stationary regeneration.
Regen Request (Allow) Lamp: The lamp
prompts the operator to implement a sta-
tionary regeneration. It is used for notifying
the operator that the regen request (allow)
switch is being activated.
Regen (Cancel): The right side of the toggle
switch is used for delaying or cancelling a
reset or stationary regeneration.
Regen (Cancel) Lamp: The lamp is used for
notifying the operator that the reset/sta-
tionary regeneration is in a “standby” mode.
6. Keyswitch – In a clockwise rotation, the
positions are:
• OFF Position – With the key verti-
cal, power from the battery is discon-
nected from the controls and
instrument panel electrical circuits. This is the only position from which
the key can be inserted or removed.
• ON (or RUN) Position – With the key turned one position clockwise
from vertical, power from the battery is supplied to all control and instru-
ment panel circuits.
• START Position – With the key turned fully clockwise, the electric
starter engages, to start the engine. Release the key to RUN position after
the engine starts.
1
2
3
4
Figure 13 Right Panel
8
5
7
6
To Next Page
Loading...
