102 50950106/AP0313
Auxiliary hydraulics
do not function.
Restraint bar raised. Lower the restraint bar.
Pilot solenoids
malfunctioning.
Check electrical connections
to pilot solenoids, repair
connections as needed. If
still not functioning properly,
contact your dealer.
Control handle
malfunctioning.
Contact your dealer.
Auxiliary hydraulic control
module malfunctioning
(located behind swell latch
panel at operator’s right foot
area).
Contact your dealer.
Restraint bar or seat switch
malfunctioning.
Contact your dealer.
High-flow auxiliary
functions slowly.
Low engine speed. Operate engine at higher
speed.
Hydraulic oil level low. Add oil.
Hydraulic oil viscosity too
heavy.
Control linkage misadjusted.
Allow longer warm-up, or
replace oil with proper
viscosity oil.
Readjust linkage for full
spool travel.
High-flow auxiliary
does not function.
Restraint bar raised. Lower the restraint bar.
Pilot solenoids
malfunctioning.
Check electrical connections
to solenoid, repair
connections as needed. If
still not functioning properly,
contact your dealer.
Switch malfunctioning. Contact your dealer.
Module malfunctioning. Contact your dealer.
Solenoid malfunctioning. Contact your dealer.
Restraint bar or switch
malfunctioning.
Contact your dealer.
Hydraulic System
Problem Possible Cause Remedy
To Next Page
Loading...
