○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
96 User Guide
○○○○○○○○○○○○○
The Sample Edit parameters
Once captured, the Sample can be edited by means of specific editing parameters. As soon as you have
sampled, the PAGE buttons are enabled for the change of page relating to the sample edit functions.
The DIAL modifies the value of the parameters shown in the 3 digit display area.
REVERB
Allows you to control the amount of Reverb applied to the sample.
The amount of Reverb applied can vary from 0 (sample with no effect) to 15 (sample with maximum effect).
NB. Check that the REVERB function is selected (corresponding display indicator on) to hear the changes
applied to the parameter.
Assignable values: 0 … 15.
CHORUS
Allows you to control the amount of Chorus (or other modulation effect) applied to the sample.
The amount of Chorus effect applied can vary from 0 (sample with no effect) to 15 (sample with maximum
effect).
NB. Check that the CHORUS function is selected (corresponding display indicator on) to hear the changes
applied to the parameter.
Assignable values: 0 … 15.
VOLUME
Determines the general volume of the sample.
Assignable values: 0 ... 16.
PAN
Determines the position of the sample within the stereo panorama.
Assignable values: L31 (all to the left) … 00 (centre) … R31 (all to the right), Mute (does not play).
TUNING
Applies a fine tune to the sample, up to one semitone above or below the actual pitch.
Assignable values: -8 … 0 … +8
To Next Page
Loading...
Need help?
General
