Rev. 00 04/19
16
Product description OptiCenter OC06
Field of application
The powder management center is suitable for use in plants with a
completely closed powder circuit:
Conveying
– Fresh powder directly from the (original) powder bag
– Fresh powder from a Gema fresh powder system
– Powder directly from the optional powder hopper
– Precision conveying from the OptiSpeeder to the applicators
– Recovered powder is returned to the system or target container
– Powder level monitoring by level sensor(s)
Cleaning
– Automatic internal cleaning of suction tubes, powder conveyors,
powder hoses and guns
– Supply of the recovered powder
– Closed powder circuit – no powder escaping during coating or
cleaning procedure. This prevents powder loss, and the workplace
and the environment remain clean.
Reasonably foreseeable misuse
– Operation without the proper training
– Use of moist powder
– Insufficient fluidization at the suction point
– Use with insufficient compressed air quality
– Input pressure too low
– Use in connection with unauthorized coating devices or components
To Next Page
