Rev. 00 04/19
60
Operation OptiCenter OC06
Coating without powder recovery (spray to waste
container)
1.
2.
3. If a US sieve** has already been configured, insert and close the
OptiSpeeder cover with the appropriate mesh size
– If there are several mesh sizes, the corresponding menu
appears for selecting the mesh size used
Overheating of the US sieve**
The US sieve can break if it has already been configured in the
configuration menu and is not inserted in the OptiSpeeder (dry
operation).
► Insert US sieve into the OptiSpeeder
Clogging of the US sieve**
The US sieve can become clogged if it has not been configured in
the configuration menu and is still inserted in the OptiSpeeder
(operation without or with insufficient sieving capacity).
► Set US sieve parameters correctly
To Next Page
