Rev. 00 03/19
OptiStar 4.0 (CG24-CP) Product description
23
Adjustable operating mode (Program mode)
In this operating mode, 250 individually definable programs (P001-P250)
are available. These programs are automatically saved and can be
recalled again as the application requires.
Fig.
The values for current, high voltage, powder output, total air and electrode
rinsing air can be set as needed for a given application.
The settings defined in the 250 programs and 3 application
modes are automatically stored, without confirmation!
Precise Control of spraying Current (PCC Mode)
For coating components with both complex and simple geometries, a
spraying current of below 10 µA can be selected to prevent unintended
overcoating on the simpler surfaces. This is especially important in
combination with high loading powders (such as metallic). The controller
automatically switches into "PCC mode". This allows for very fast yet
highly precise control. The high voltage and spray current values and their
symbols are depicted in red:
Fig.
: PCC mode
To Next Page
Loading...
